Home   OpenBridge   Monitor   Lastheard   System Info   


Options Explanation.

Information.
Options=TS1=2350;TS2=2350;DIAL=0;TIMER=10;VOICE=0;SINGLE=0;LANG=0;


TS1=2350,235;

Set Statics you want on Slot 1.  Separate each Talk Group with a comma.
At the end of each section you need a Semicolon.


TS2=2350,2351;

Set Statics you want on Slot 2.  Separate each Talk Group with a comma.
At the end of each section you need a Semicolon.


DIAL=2350;

0=None. Set default Enhanced Talk Groups (Dial-a-TG) TG9 Slot 2.
Only One Talk Group can be entered in this section.
You should not have the same Talk Group set as static on Slot 1 or Slot 2.
At the end of each section you need a Semicolon.


TIMER=10;

Time a Talk Group is held active for.  Pressing your PTT on a Talk Group reset this timer.
You select any number of minutes you like here.  But the recommended time is 10 or 5 mins.
If setting more than two static to a slot, you might wish to set Timer to  1 or 2 min.
At the end of each section you need a Semicolon.


VOICE=0;

0=OFF  1=ON.  15 minute Voice Ident can be set ON or OFF on Time Slot 2.
Radios will RX from the network "This is CALL-SIGN FreeDMR. "
At the end of each section you need a Semicolon.


SINGLE=0;

Turn off Single Mode. Network default is ON=0. OFF=1.
At the end of each section you need a Semicolon.


LANG=0;

Set the Language the VOICE comes back to you as.  0=Servers Default.
At the end of each section you need a Semicolon.


Each section is separated with a Semicolon. "Does not matter what order the above codes are in".